Panasonic KX-FP101 - Manual (Page 66)

Receiving Faxes
Extension teiephone
When you connect an extension telephone to your unit or on the same line, you can receive fax document
using the extension telephone.____________
You do not have to press fSTART/SET/COPY] on the unit.
Important:
• Use a touch tone telephone as the extension telephone and enter the fax activation code firmly.
1
2
When the extension telephone rings, lift the
handset of the extension telephone.
When:
— document reception is required,
— a fax calling tone {slow beep) is heard, or
— no sound is heard,
press [*] [ 9] (pre-selected fax activation code)
firmly.
Hang up the handset.
• The unit will start reception.
Fax activation code
Extension telephone
Note:
• You can change the fax activation code (see
below).
The fax activation code is used in the following cases;
— when receiving faxes using an extension telephone (see above).
— when receiving a voice message and fax document in the same call (p. 59).
Important:
• This code should be different from the remote activation ID (p. 59) and the auto disconnection code (p. 69).
1
2
3
4
5
Press (MENU).
Display:
Press @, then (4] [T).
1.SYSTEM SET UP
FAX ACTIVATION
Press [START/SET/COPYl.
MODE=ON ▼A
Press ® or ® to select “ON”.
• If this feature is not required, select “OFF”.
(MENU)
.0
OCD® ^
®CDCD
® ® ® ’ o
D D
G 0
o -—.
Press [START/SET/COPYl.
( START/SET/COPY ]
CODE= * 9
8
66
• The display will show the pre-selected code.
Enter the new code.
• This code can be from 2 to 4 digits in length
using 0-9, and *.
Press [START/SET/COPYl.
Press (MENU).
SETUP ITEM [ ]
Note:
• If you subscribe to any special telephone
company services which require a code, all
or part of the fax activation code must be
different from the service access code.
• The fax activation code should not be set to
“
0000
".