Panasonic KX-FP101 - Manual (Page 20)

Setup
Connections
1 Connect the handset cord.
Connect the telephone line cord.
Connect the power cord.
• The unit will automatically start to
detect the dialing mode of your
telephone line (see below).
• When the power is turned on for the
first time, the unit will print some
basic information.
120 V, 60 Hz
eS
Wall jack
(RJ11C)
^ D ^
( Power surge \
protector /
- Handset cord
( Line surge \ Telephone
protector / line cord
Connect to “LINE”.
Note:
• For additional equipment protection, we recommend the use of a surge protector. The following types are
available; TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
The warranty does not cover damage due to power line surges or lightning.
• When you operate this product, the power outlet should be near the product and easily accessible.
• If you want to connect an answering machine to the unit, see page 57.
Automatic dialing mode setting
• When the telephone line cord and the power cord are connected, the unit will automatically start to detect
the dialing mode of your telephone line.
Display;
CHECKING LINE
Wait until one of the following messages is displayed.
Your line has touch tone service. LINE IS TONE
LINE IS PULSE Your line has rotary pulse dial service.
• If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when
power is restored.
• If you connect the power cord before connecting the telephone line cord, the following messages will be
shown alternately.
NO TEL LINE INSERT TEL LINE
Connect the telephone line cord.
20