Panasonic SC-DV150 - Manual (Page 49)

u»
C
.0
s
&
2
c
a
0
I
0-
T}
§
5
...■■.■■.■ .:V'V
■.■■■■Vi','..
aws
vSS
SEAT
POSITION % ^■i--;Si!';->';^,>-' . _f (_ i i
L^’.' n n i~ T. T T n II I 'ti'''''Vi’
|;-‘r-.: ■■ r' (_( _/ X ' X Li ( 1/ ;'. '■■■' ;
©
DISPUY UODE
Example: Aurora display
■gм
т S b r J
O-©T0-O
©-©-1 © 6
© ©.© ©
5 Q o
OOO'
t O ‘S
MUTING
'’■''X'-'.-iX II’ I II I i~ Xx--'"-#*-. ■.
;.Xxv;,;^' I U ' X ( w O
:ÌS:''
•This function lets you adjust the listening position for better effect.
•This mode can only be turned on if ttie [SEAT POSITION] lamp is
orange. The mode cannot be used if the lamp is off.
Press [SEAT POSITION].
The [SEAT POSITION] lamp flashes green.
While the lamp is flashing change the seat position.
WithinlO seconds
Operate Joystick to adjust the seat position.
To turn off the SEAT POSITION mode
Press [SEAT POSITION] once to select the function and once again
to turn it off while the lamp flashing.
With the remote control
(D Press [AV EFFECT] ([SHiFT]+[ANGLE]).
@ Press [◄] or [►] so the [SEAT POSITION] lamp flashes.
® Press [A] (on).
@ Press [◄], [►], [▼], or [A] to adjust the seat position.
The [SEAT POSITION] lamp will stop flashing in a while.
To turn it off, after steps (T) and (|), press [T] (off).
When used with virtual rear surround,
seat position is changed in 3 horizontal
steps.
Concerning the display
E
The sound processor shows the level of each sound range with the
three types of display described below.
Press [DISPLAY MODE].
The spectrum display will change as follows.
0 Normal display
This display indicates the strength of the sound in each tonal
range.
@ Peak-hold display
The peak sound value of each sound range is held on the display
for about one second after it occurs.
@ Aurora display
The peak sound value of each sound range is displayed in invert­
ed form.
To mute the volume m
RQT5052
This feature is covenient when you have a telephone call, etc.
Press [MUTING].
To cancel
Press [MUTING] once again.
“MUTING” goes out.
To cancel from the tuner amplifier, reduce the volume to the minimum
position (-dB) and then reset to the desired volume.