DVR systems DVR31xxH Series - Manual (Page 40)

40
 Period: Click set button, you can see an interface is shown as in Figure 4-20
X
. Here you can
set for business day and non-business day. In Figure 4-20
X307H307H307HX
, click set button, you can see
an interface is shown as in Figure 4-21. Here you can set your own setup for business day
and non-business day.
 Anti-dither: Here you can set anti-dither time.
 Alarm output: when alarm occurred, system enables peripheral alarm devices.
 Tour: Here you can enable tour function when alarm occurs. It is a one-window tour. Please
go to chapter 5.3.9 Display for tour interval setup.
 Buzzer: Highlight icon to enable this function. The buzzer beeps when alarm occurs.
Please highlight icon to select the corresponding function. After all the setups please click
save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in
each channel may not be the same.
In Figure 4-18, you can left click mouse and then drag it to set a region for motion detection.
Click Fn to switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure 4-17
Figure 4-18