DVR systems DVR31xxH Series - Manual (Page 101)

101
Parameter Function
PPPOE  Input the PPPoE user name and password you get from the
IPS (internet service provider) and enable PPPoE function.
Please save current setup and then reboot the device to
get the setup activated.
 Device connects to the internet via PPPoE after reboot.
You can get the IP address in the WAN from the IP address
column.
 Please note if you want to reboot the device please make
sure you have proper reboot right and there is no login user
in current device.
Email
The email interface is shown as in
X463H463H463H
Figure 7-33
X
.
Figure 7-33
Please refer to the following sheet for detailed information.
Parameter Function
SMTP Server
Input server address and then enable this function.
Port Default value is 25. You can modify it if necessary.
User Name
The sender email account user name.
Password
The sender email account password.
Sender
Sender email address.
Subject
Input email subject here.
Address
Input receiver email address here. Max input three addresses.
DDNS
The DDNS interface is shown as in
X464H464H464H
Figure 7-34
X
.
Please make sure your DVR support this function.