CANOGA PERKINS 3240S SNMP Managed Fiber Optic Multiplexer - Manual (Page 61)

3240S F I B E R O P T I C M U L T I P L E X E R
3240S Fiber Optic Multiplexer
4.8.6.2 Enter SLIP Mode
To enter SLIP mode select 2, then Enter from the SLIP configuration menu. After entering a SLIP mode the serial port will not
display further messages, but will begin to assemble IP packets at the serial port. Only those IP packets addressed to the SLIP
will receive a response. When the serial port receives three carriage returns outside of the SLIP packet or goes through a
reset, the mode reverts to console. If a user interface password has been configured, you will be required to enter it prior to
returning to console mode. Reference Figure 4-16.
Figure 4-16
Entering SLIP Mode
4-19