WEATHER GUARD Model 252-3-02 EZ-GLIDE® System, Full-Size, GM - Manual (Page 14)

STEP 22
WITH HELP! Place entire unit on vehicle in desired position. Check to verify that the Handle clears the rear of the van.
It may be necessary to move the rack to the rear.
STEP 23
Install the Vinyl Tubes (A) on vehicle gutters
(centered on the Mounting Bases).
Passenger Side Shown
NOTE:
Rotation section
and gutter clamp not
shown for clarity
(A)
STEP 24
First snug the carriage bolts (A) and then tighten the bent bolts (B). Fully tighten
the carriage bolts last.
Passenger Side Shown
NOTE:
Rotation section not shown for clarity
(A) 1-1/2" Long
Carriage Bolt
(B)
NOTE: Tighten all loose
fasteners at this time.
STEP 20 (DRIVER SIDE Rear)
FORD & DODGE ONLY
The GM Rear Cross-Member has one set of holes
as shown in Step 19
(A)
(2) 5/16-18 x 2-3/4"
Hex Hd. Bolt
(4) 5/16-18 Flat
Washer
5/16-18 Nylon
Lock Nut
(B)
NOTE: To allow for final
fit-up, do not tighten
these fasteners at this
time.
Use these two
holes for Dodge
Use these two
holes for Ford
STEP 21 (DRIVER SIDE Rear)
Attach Mounting Base with
Gusset and Clamp (A) to
Cross-Member (B)
with 5/16-18 x 2-3/4"
Fasteners.
(A) 2" Long
Carriage Bolt
(B)
MODEL 252
GM APPLICATION
MODEL 251
FORD APPLICATION
NOTE: At the end of the first week
of use, check all fasteners for proper
tightness and then every three
months thereafter.
14