B&C Technologies SA Series Industrial - Manual (Page 47)

OPERATING INSTRUCTIONS
4-25
Memory Erasure
Function 181
Function 220
Partial or total clearing of the control memory is possible. Function 220 clears all programs
and cycles, but machine parameters are not erased. Function 181 erases all programs and cycles,
and also erases all machine parameters, thus reinitializing the control. After keying in the function,
the display reads: “DELETE EEPROM?” Press ENTER to confirm. Press RESET to abort the
procedure.
Memory Card
Function 222
Function 223
The control allows transfer of programs from and to a credit card sized memory card. This
allows great flexibility in programming. The card must be inserted into the control with the contacts
facing up. Card insertion and removal must be done with the machine powered down.
Function 221
To transfer programs, cycles and parameters onto the memory card, use function 221.
1. Power down the machine
2. Insert the memory card
3. START + RESET
4. 221
5. ENTER the display now shows “COPY TO M. CARD?”
6. Press ENTER the display now shows “COPY TO CARD” followed by “COPY OK.”
Function 222
Function 222 works exactly like function 221, except it transfers programs and cycles from
the memory card to the control.
1. Power down the machine
2. Insert the memory card
3. START + RESET
4. 221
5. ENTER the display now shows “COPY FROM M. CARD?”
6. Press ENTER The display now shows “COPY FROM CARD” followed by “COPY OK.”
Function 223
Function 223 works exactly like function 222, except it transfers programs, cycles and
machine parameters from the memory card to the control.
1. Power down the machine
2. Insert the memory card
3. START + RESET