B&C Technologies SA Series Industrial - Manual (Page 27)

OPERATING INSTRUCTIONS
4-5
To access this mode, press START and RESET together, then at the prompt, key in the
desired number.
Programming
12 Programming cycles
27 Creation of Programs
45 Programming motors
System Setup
118 Disable Machine
181 Resets controller – erases all memory
201 Language option (1 – Italian, 2 – English, 3 – German, 4 – Spanish, 5 – French)
205 16 or 24 outputs
207 Maximum RPM
209 Temperature Hysterisis (min 1 deg, max 10 deg) Default is 3 deg.
210 Display temperature in degrees C
211 Display temperature in degrees F
212 Maximum water level that can be set (10 – 100 cm.)
213 Minimum water level for heating (2 – 30 cm.)
214 Display number of hours of operation
215 Display total number of washes
216 Display number of washes since the last maintenance
217 Reset maintenance request
218 Display and set number of washes until maintenance request
219 Spin slow down time (40 – 200 sec)
220 Erases Programs and cycles
221 Copy from control to memory card
222 Copy from memory card to control (only programs and cycles)
223 Copy from memory card to control (programs, cycles, and parameters)
225 Disables Advance Key
230 Maximum water level allowed during spin (2 – 60 cm.)
Highlighted items are safety related and should not be changed.
Do not alter these values without consulting a qualified technician.
Programming
Programming the WC03 takes place on three levels:
1. Programming motors (45)
Allows 15 different operating modes to be created for each mode, the clockwise rotation time,
the counterclockwise rotation time and the pause time can be programmed.
2. Programming the cycles (12)
For each sequence of steps, creates a sequence of events in which various functions can be
activated or deactivated (drain, cold fill, spin, etc.). Going from one step to another may require
reaching a water level or temperature, or a time value. There are five different programmable cycle