Welch Allyn Corival V2 - User Manual - Manual (Page 22)

Operator Manual Corival
22
14.
Select Recovery the ▲ ♥ keys and change the Workload to 35 and press the
confirmation button.
15. After confirmation you will automatically go to the BPM menu.
16. Select No BPM when the BPM module is not installed or select Repeat with the ▲ ♥
keys and choose 2 minutes for the repeat time, confirm with ( ) and choose 2 minutes
for the repeat time in the recovery stage. The protocol TEST (with BPM) is ready
now, you can go to protocol RUN to test this special protocol (not for normal use).
To edit an existing protocol, you have to select the desired protocol first. You can change the
name or confirm the name with OK ( ) ten times. Now you can walk through the stages with
the confirmation button, until you reach the stage you want to edit. You have to scroll through
the total protocol and define the recovery stage before you leave this menu otherwise the
changes will not be saved.
B.3.7.3 Protocol Run
The menu PROTOCOL RUN is used to select the desired protocol for the exercise test. Select
Protocol Run and three previously programmed protocols will appear on screen. To scroll
through the total list use the arrows, for instance:
If you want to select e.g. the protocol 10 w min, use the ▲ key until a space appears in front of
the name of the protocol (the selectable item is always on the 2
nd
line) and confirm with ok.
The following message will appear on screen:
This screen is used to check the selected protocol; in this case the name is 10w min: the first
step will start with 10 watt for 1 minute. Press the confirmation button to go on:
test
Ramp P=160W t=09:40
6P dP=-060W dt=060s
esc next
10w min
25w 2 min
ramp 400w
esc ok
10w min
1 P=0W t=00:00
1S dP=+10W dt=060s
esc ok