Welch Allyn CP 200 12-Lead Resting Electrocardiograph - User Manual - Manual (Page 89)

Directions for Use Chapter 7 Maintaining the Electrocardiograph 85
9. Replace the battery door and screws. Turn the electrocardiograph rightside-up.
It turns on automatically and displays a prompt to enter date and time.
10. Enter the date and time.
The electrocardiograph is ready to use.
11. Discard the old battery appropriately.
• In the USA, call 1-800-SAV-LEAD for instructions on how to recycle it.
• International users, contact your local authorities concerning recycling.
Replacing the Battery (DC) Fuse
If the battery (DC) fuse requires replacing, as described in Step 5 on page 83, follow these
steps. For the fuse value, see “Fuses” on page 95.
1. Remove and discard the fuse. See Figure 55 .
You may need to pull hard. Use pliers gently if necessary.
2. Connect a new fuse. It goes in either way.
3. Go to Step 8 on page 84.
Figure 55. Battery Fuse Removed