beautypg.com

Status/error messages, Display messages – Welch Allyn OAE Hearing Screener - User Manual User Manual

Page 10

background image

Status/Error messages

Display messages

Message

Definition

Attach Probe

No probe is detected at the start of a test.

Device not Responding

The printer is not responding to queries from the instrument.

BT Device Not Found.

The paired Bluetooth

®

device cannot be detected by the

screener. The screener may be turned off or too far away.

BT Error #xxx.

There is an error condition with the Bluetooth

®

device. Check

the status.

BT Not Configured

The screener is not paired with any Bluetooth

®

device.

Fit Error Cannot Obtain P

For a DP test, the desired intensity level (L1 or L2) cannot be

obtained within allowable limits. Refit the eartip and probe and

attempt the test.

Fit Error Too High

The level of the calibration tone is too high. Refit the eartip and

probe and retry the test.

Fit Error Too Low

The level of the calibration tone is too low. Refit the eartip and

probe and retry the test.

Limit Error

Overflow error during the calculation of the DFTs for a DP test.

Repeat the test.

Memory Almost Full

Saved tests are within 5 tests of the 250 maximum limit.

Memory Full!

The maximum saved test limit of 250 is reached. Clear the

memory before any additional tests can be performed.

Power Low!

The battery charge level is too low for operation. Charge the

battery in order to administer additional tests.

Printer Error

There is a problem with the printer. Check the printer status.

Printer Paper Out!

The printer paper has run out. Load printer paper.

Time/Date Error

The clock is checked during power on to ensure it has not lost

time and been reset. In the case of clock reset, this message is

shown. Set the correct date/time.

6 About warnings and cautions

Welch Allyn

®

OAE Hearing Screener