Vintage Cellars FGD-0400 User Manual
Page 92
2. Press STATUS.
STATUS
Sections 6.2.1, 6.2.2, and 6.2.3 demonstrate two different Status
Report recitations. The Status Report starts with:
“Hello. This is 555-1234 (or the programmed ID), (Custom ID
Message).”
“It is now 12:15
PM
(or the current time).”
The Model 400 proceeds with a separate report for each zone.
Each zone identifies itself by reciting the zone number and it’s
associated voice message.
6.2.1 Example: Status Report, No Alarms
Zones 2, 3, and 4 are configured as dry contact and zone 1 is
configured as temperature. No alarms exist. The Status Report
begins by saying, “Hello, this is 555-1234, this is building M,
third floor; it is now 2:30
PM
.”
Following this introduction, the report continues:
“Zone 1, room temperature, 74 degrees, OK.”
“Zone 2, door alarm, OK.”
“Zone 3, ups alarm, OK.”
“Zone 4, water sensor, OK.”
“The sound is OK.”
“The power is ON.” This refers to AC power.
“The batteries are OK.” Other possible responses: “Batteries
are low” or “Replace batteries.” (Refer to Section 6.2.4 for
additional information regarding battery condition.)
“The output is off.”
“Listen to the sound for 10 seconds.” In this case, the
programmed Listen-in Time is set at 10 seconds. (This feature is
not available when obtaining the Status Report on-site, directly at
the keypad.)
The Status Report repeats once more and the Model 400
concludes the call, saying: “Goodbye.” (The Status Report will
Sensaphone
®
Model 400 User’s Manual
89