Rice Lake OnTrak Truck Scale Data Management - Operation Manual - Manual (Page 33)

Making Weighments 29
Figure 5-2. Kiosk configuration settings.
4. Under Scale One , select Kiosk Communications. The right pane’s options will depend on the kiosk
communications method selected in Step 3.
5. If TCP/IP was selected for the kiosk communications method in Step 3, specify the IP address and TCP
port.
Figure 5-3. Kiosk Communications settings. TCP/IP (left) RS-232 (right).
6. If RS-232 was selected for the kiosk communications method in Step 3, use the drop-down menus to
specify the communications port, data bits, stop bits, baud rate, and parity.
7. To begin automated kiosk mode, click Save .
5.2 Manual Weigh-Ins
Before you weigh-in a truck, you must have the truck already entered in the OnTrak database. Customer, product,
and job information may also be entered, but are not required. Refer to Section 4.0 on page 19.
1. From the OnTrak main screen, select whether you are in shipping mode or receiving mode.
Shipping mode is used when product is leaving your facility; receiving mode is used when product is coming
in.
2. From the Truck pull-down menu, select the customer’s truck that is being used.
Note