Rice Lake OnTrak Truck Scale Data Management - Operation Manual - Manual (Page 14)

10 OnTrak Manual
3.2 Scale Settings
You may be using a one- or two-scale system. If you are using a two-scale system, both scales need to be
configured. If you are using a one-scale system, you can ignore
Scale Two options.
3.2.1 Scale One
1. From the Tools menu, select Options.
The Options dialog box appears.
Figure 3-5. Options dialog box, Scale One Setup selected.
2. From the left pane, expand the Scale One selection, if not already expanded.
3. Under Scale One , select Setup .
4. From the Scale One Driver pull-down menu, select the indicator connected to scale one.
5. From the Source Channel pull-down menu, select the desired channel you want to use.
Channel selection options will vary depending on which indicator is selected in Step 4. If you are
using an indicator with multiple channels, and a two-scale system, you can select one channel for
scale one and a different channel for scale two, if you desire.
6. From the Communications Method pull-down menu, select whether the indicator is connected via RS-232
or TCP/IP.
7. In the Scale Label text box, type a desired name for the scale.
8. Under Scale One , select Communications .
9. In the right pane, specify the correct communications options. The options available will depend on
whether you selected RS-232 or TCP/IP in Step 6.
Figure 3-6. RS-232 communication options. Figure 3-7. TCP/IP communication options.
10. Under Scale One , select Kiosk. In the right pane, mark the checkbox to enable automated kiosk for scale
one. Use the pull-down menus to specify the kiosk communications method, printer driver, and Windows
printer name.
Note