Rice Lake OnTrak Truck Scale Data Management - Operation Manual - Manual (Page 15)

Setting up OnTrak 11
Figure 3-8. Kiosk configuration settings.
11. Under Scale One , select Kiosk Communications. The right pane’s options will depend on the kiosk
communications method selected in Step 10.
12. If TCP/IP was selected for the kiosk communications method in Step 10, specify the IP address and TCP
port.
Figure 3-9. Kiosk Communications settings. TCP/IP (left) RS-232 (right).
13. If RS-232 was selected for the kiosk communications method in Step 10, use the drop-down menus to
specify the communications port, data bits, stop bits, baud rate, and parity.
3.2.2 Scale Two
1. From the left pane, expand the Scale Two selection.
2. Under Scale Two , select Setup .
3. From the Scale Two Driver pull-down menu, select the indicator connected to scale two.
If you are using one multi-channel indicator for both scales, select Same as Scale One .
4. From the Source Channel pull-down menu, select the desired channel you want to use.
Channel selection options will vary depending on which indicator is selected in Step 3. If you are using one
multi-channel indicator, ensure you choose a different channel for scale two than the channel used in scale
one.
5. From the Communications Method pull-down menu, select whether the indicator is connected via RS-232
or TCP/IP.
6. In the Scale Label text box, type a desired name for the scale.
7. Under Scale Two , select Communications .
8. In the right pane, specify the correct communications options. The options available will depend on
whether you selected RS-232 or TCP/IP in Step 5. See Figure 3-6 and Figure 3-7.
Note