Rice Lake CLS-420 Cargo Lift Scale Installation Manual - Manual (Page 41)

CLS-420 Installation Manual 31
5.2.5 Program Menu
XXXXXXX XXXXXXX
PWRUPM
GO
OIML
REGULA
000000
number
CONSNU
DELAY
SETPNT PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT
000000
number
CONSTU
NTEP
CANADA
1
UID
VERS DIGIN ALGOUT
DATFMT
MMDDYY
DATE
DDMMYY
YYMMDD
YYDDMM
DATSEP
SLASH
DASH
SEMI
TIMFMT
12HOUR
TIME
24HOUR
TIMSEP
COLON
COMA
NONE
COUNT
ACCESS
SPLISIZ
ACCUM
ON/OFF
ON
ON
RTZGRD
0
Figure 5-9. Program Menu
Program Menu
Parameter Choices Description
Level 2 submenus
PWRUPM GO
DELAY Power up mode. In GO mode, the indicator goes into operation immediately after a brief
power up display test.
In DELAY mode, the indicator performs a power up display test, then enters a 30-second
warm up period. If no motion is detected during the warm up period, the indicator becomes
operational when the warm up period ends; if motion is detected, the delay timer is reset
and the warm up period repeated.
COUNT ACCESS
SPLSIZ Specifies whether the operator has access to piece count mode and the default sample size
used for parts counting. See level three submenu for parameter descriptions.
REGULA NTEP
OIML
CANADA
NONE Regulatory mode. Specifies the regulatory agency having jurisdiction over the scale site.
OIML, NTEP, and CANADA modes allow a tare to be acquired at any weight greater than
zero, NONE allows tares to be acquired at any weight value.
OIML, NTEP, and CANADA modes allow a tare to be cleared only if the gross weight is at no
load. NONE allows tares to be cleared at any weight value.
NTEP and OIML modes allow a new tare to be acquired even if a tare is already present. In
CANADA mode, the previous tare must be cleared before a new tare can be acquired.
NONE, NTEP, and CANADA modes allow the scale to be zeroed in either gross or net mode
as long as the current weight is within the specified ZRANGE. In OIML mode, the scale must
be in gross mode before it can be zeroed; pressing the ZERO key in net mode clears the
tare.
CONSNU 000000
number Consecutive numbering. Allows sequential numbering for print operations. The consecutive
number value is incremented following each print operation.
The initial value of this parameter is set to the start up value specified on the CONSTU
parameter. Changing either CONSTU or CONSNU immediately resets the consecutive
number used for printing.
CONSTU 000000
number Consecutive number start up value. Specifies the initial consecutive number (CONSNU)
value used when the indicator is powered on.
UID 1 Specifies the unit identification number. Value specified can be any numeric value, up to six
digits.
Table 5-7. FEATURE Menu Parameters