Rice Lake CLS-420 Cargo Lift Scale Installation Manual - Manual (Page 39)

CLS-420 Installation Manual 29
5.2.4 SERIAL Menu
Figure 5-8 illustrates the serial menu and their associated settings for the functionality of the CLS-420 Cargo Lift
Scale. It should be noted that the EDP port is dedicated to the two channel iQube communication and is
automatically set when the SSCALE parameter is set to 2LCELL. Table
5-5 below, illustrates the different serial
settings used for CLS functionality and a basic 420 indicator.
XXXXXXX XXXXXXX XXXXXXX XXXXXXX
EOLDLY
000
number
EDP PRINT
PRN
EDP
PRNDES
BITS TERMIN BAUD
CR
9600
7ODD
7EVEN
8NONE CR/LF
4800
2400
1200
600
300
Same as EDP
EDP
OFF
STREAM
PRN
ALGOUT DIGIN SETPNT PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT
ECHO
ON
OFF
VERS
19200
38400
The print port is labeled Serial to the CPU board.
2LCELL
OFF
SSCALE
4LCELL
LFT
INDUST
STRRTE
OFF
ON
SS-LFT
OFF
ON
PRNMSG
Figure 5-8. CLS-420 SERIAL Menu
Table 5-5. SSCALE Parameter Settings
SSCALE Parameter Settings
Parameter If set to OFF If set to 2LCELL
Baud 9600 19200
Bits 8 None 8 None
Termin CR/LF CR
EOLDLY 000 000
Echo On Off
Note
The SSCALE parameter on the serial menu must be set to 2LCELL for use with the CLS-420 Cargo Lift Scale. If
it is set to OFF, then the 420 indicator will function with a standard 420 calibration menu.