Rice Lake Intrinsically Safe - Manual (Page 37)

320IS Installation Manual - Configuration 31
Table 3-7. Digital Input Menu Parameters
3.3.7 Analog Output Menu
The ALGOUT menu is used only if the
320IS
is used with the I/O Module option. If the I/O Module is installed and
the analog output is being used, configure all other indicator functions and calibrate the indicator (see See
Section 4.0 on page 33) before configuring the analog output. See Section 7.8 on page 55 for analog output
calibration procedures.
Figure 3-8. Analog Output Menu
DIG IN Menu
Parameter Choices Description
Level 2 submenus
DIGIN1
DIGIN2
DIGIN3
DIGIN4 OFF

ZERO
TARE
NT/GRS
NET
GROSS
UNITS
PRIUNI
SECUNI
DSPTAR
PRINT
CLRCN
KBDLOC
HOLD
CLRTAR
CLRACC
ACCUM
ENTER
NEWID
Specifies the function activated by digital inputs 1– 4.
• ZERO, NT/GRS (net/gross mode toggle), TARE, UNITS, and PRINT provide the same
functions as the front panel keys.
• DSPTAR displays the current tare value.
• CLRCN resets the consecutive number to the value specified on the CONSTU parameter
(PROGRM menu).
• KBDLOC disables the keypad while the digital input is held low.
• HOLD holds the current display. Releasing this input clears the running average filter.
• CLRTAR clears the current tare.
• CLRACC clears the accumulator.
• ACCUM displays the current accumulator value.
• ENTER simulates pressing the ENTER key in weigh mode (for setpoint and checkweigh
value changes from the front panel).
• GROSS, NET, PRIUNI, and SECUNI select gross, net, primary units or secondary display
modes.
• NEWID enters the ID number.
SOURCE
GROSS 0%
20%
OFFSET ERRACT
FULLSC
HOLD
000000
number
MIN
10000
number
MAX TWZERO
NET
TWSPAN
ZEROSC
ALOUT1
0
number
65300
number
ALOUT2
XXXXXXX XXXXXXX XXXXXXX XXXXXXX VERS ALGOUT DIG IN PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT XXXXXXX SETPNT
SOURCE
GROSS 0%
20%
OFFSET ERRACT
FULLSC
HOLD
000000
number
MIN
10000
number
MAX TWZERO
NET
TWSPAN
ZEROSC
0
number
65300
number