Navigation, Introduction – Mercedes-Benz G-Class 2010 COMAND Manual User Manual
Page 58
also activate the symbol displays for
several POIs.
R
No Symbols
i
The list indicates all symbols for all
countries that are contained in the digital
map. However, not all POIs are availbale in
all countries. As a result, certain POI
symbols may not be shown on the map
even though the symbol display is switched
on.
X
To exit menu: Press = or ;.
X
Hide menu system if applicable
(
Route Mode
This function allows you to set the following
options for route guidance:
R
Avoid Highways
R
Avoid Toll Roads
R
Avoid Tunnels
R
Avoid Ferries
R
Avoid AutoTrains
1
Sets route options
Setting Route Options
X
To set: Display menu system is applicable
X
Select
Navi£Mode.
X
To switch option on/off: Select required
option.
Depending on the previous status, the
option will be switched on Ç or offc.
You may activate several options.
i
The calculated route may include ferry
connections, for example, even if the
operation
Avoid Ferries has been
activated.
i
If you change the route type setting when
route guidance is active, COMAND
calculates a new route.
Block Area
You can define an area within the map display
that is not to be used by the system in
calculating a route, if possible.
i
The calculated route may include a
blocked area if the destination is within a
blocked area or if the destination can only
be reached using roads that lead through a
blocked area. Highways cannot be blocked.
X
To set, change or delete: Display menu
X
Select
Navi £Block Area.
If no areas were previously set, the map
display appears ready to select an area.
If areas were previously set, the blocked
area list appears.
X
To move the map: Press
9, :,; or =.
X
To set the map scale: Press U or
T.
The map scale is displayed.
56
Introduction
Navigation