Mercedes-Benz GLK-Class 2011 COMAND Manual - Manual (Page 91)

X To switch on navigation mode: press the
g function button.
X To show the menu: press W the COMAND
controller.
X Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X Select Block Area and press W to
confirm.
If you have not yet set any area to be
avoided, you will see the map with the
crosshair (option 1).
If you have previously set one or more areas
to be avoided, you will see a list (option 2).
Option 1: the map
X To scroll the map: slide the COMAND
controller XVY, ZVÆ or aVb.
X To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map, turning counter-clockwise zooms
in.
X Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
controller.
A red square appears on the map.
X
To adjust the size of the square: turn
cVd the COMAND controller.
The square is enlarged or reduced.
X To confirm the settings: press W.
The list appears. The previously selected
area to be avoided has been added and
activated.
X Follow the instructions listed under "Option
2: the list".
Option 2: the list appears
X Select Avoid New Area by turning cVd
the COMAND controller and press W to
confirm.
The map with the crosshair appears.
X Proceed as described under "Option 1: the
map" if you wish to set a new area to be
avoided.
Switching an avoided area on/off
X Select an entry in the list by turning cVd
the COMAND controller and press W to
confirm.
The avoided area is switched on O or off
ª, depending on the previous status.
Displaying and changing an avoided
area
X Select an entry in the list by turning cVd
the COMAND controller.
X Select Options by sliding VY the
COMAND controller and press W to
confirm.
Other settings
89
Na
vigation
ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl Version: 3.0.3.6
2010-05-31T09:21:57+02:00 - Seite 89
Z