Mercedes-Benz GLK-Class 2011 COMAND Manual - Manual (Page 36)

MLP
Switching surround sound on/off
Example: switching on surround sound for
radio mode
X Press the ó function button.
The radio display appears. You will hear the
last station played on the last waveband.
X Select Sound by sliding VÆ and turning
cVd the COMAND controller and press
W to confirm.
X Select Surround and press W to confirm.
X Select Logic7 ® On or Logic7 ® Off by
turning cVd the COMAND controller and
press W to confirm.
Depending on your selection, surround
sound is switched on or off and the menu
is exited.
X To exit the menu without saving: press
the k back button or slide XVY the
COMAND controller.
i Please note the following: for the
optimum audio experience for all
passengers when Logic7 ® is switched on,
the balance and fade should be set to the
center of the passenger compartment.
You will achieve the best sound results by
playing high-quality audio and video DVDs.
MP3 tracks should have a bit rate of at least
128 kbit/s.
Surround sound playback does not
function for mono signal sources, such as
the AM radio mode.
If radio reception is poor, e.g. in a tunnel,
you should switch off Logic 7 ® , as it may
otherwise switch between stereo and
mono and cause temporary sound
distortions.
On some stereo recordings, the sound
characteristics may differ from
conventional stereo playback.
Rear view camera
G Warning!
The rear view camera is merely an aid.
Please observe the corresponding notes in
your vehicle's Operator's Manual.
If your vehicle is equipped with a rear view
camera, its image is automatically relayed to
the COMAND display if the function is
activated and you shift into reverse gear.
If the function is activated, the COMAND
display will automatically switch back to the
34
Rear view camera
At
a
glanc
e
ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl Version: 3.0.3.6
2010-05-31T09:21:57+02:00 - Seite 34