Na viga tion, Entering destinations – Mercedes-Benz GLK-Class 2011 COMAND Manual User Manual
Page 62
recalculates the route to the main
destination.
Entering predefined destinations
X
To switch on navigation mode: press the
g function button.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X
Select Stopover and press W to confirm.
Option 1: no intermediate stop has been
entered yet.
X
Select a category, see option 2.
Option 2: an intermediate stop has
already been entered.
X
Select Change Stopover and press W to
confirm.
X
To select a category: select a category by
turning cVd the COMAND controller and
press W to confirm.
COMAND first searches in the selected
category for destinations along the route.
If there are no destinations available there,
COMAND searches for destinations within
a radius of up to 100 km of the vehicle
position.
If COMAND finds destinations, a list
appears on the right-hand side of the
display.
The intermediate stops are listed according
to increasing distance from the current
vehicle position. They are displayed in the
form of a name and their position in relation
to the route and your direction of travel.
i
For intermediate stops that are not
located along the calculated route, the
linear distance is shown.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Confirm OK by pressing W.
X
Select a different category.
X
Select the intermediate stop by turning
cVd the COMAND controller and press
W to confirm.
The address entry menu appears, showing
the destination address.
X
To start route calculation: select Start
and press W to confirm.
Entering another destination as an
intermediate stop
X
To switch on navigation mode: press the
g function button.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X
Select Stopover and press W to confirm.
X
Select Other and press W to confirm.
X
Select Address Entry, From Memory,
From Last Destinations or From POIs.
Selection
Step
Address Entry
X
Enter a
destination by
address
(
Y
page 51).
From Memory
X
Select a
destination from
the destination
memory
(
Y
page 57).
60
Entering destinations
Na
viga
tion
ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl
Version: 3.0.3.6
2010-05-31T09:21:57+02:00 - Seite 60