Mercedes-Benz GLK-Class 2011 COMAND Manual - Manual (Page 145)

(for the USA) or Customer Relations at
1-800-387-0100 (for Canada).
Connecting an external device
i Do not leave external devices in your
vehicle as extreme temperatures (e.g.
caused by direct sunlight or extremely low
outside temperatures) can effect
functionality (see the operating
instructions for the respective device).
Mercedes-Benz USA, LLC does not take
responsibility for any damage to external
devices.
Never connect more than one device at a
time. You will otherwise not be able to play
back from the external device.
: 4-pin socket for ⅛ inch stereo jack, e.g.
for MP3 players (audio and video)
; iPod socket, to connect an iPod ®
= USB socket, to connect a USB device
? Example of device (iPod ® )
X Connect the external device with suitable
socket :, ; or =.
COMAND activates the device.
If you remove a device, the No Device
Connected message appears.
i A connected iPod ® or MP3 player should
not be simultaneously operated via the
Media Interface and the remote control
(e.g. Bluetooth ® remote control), as this
may produce unpredictable results.
i Connecting a fully discharged iPod ® or
MP3 player can result in an extended
initialization period.
Error messages appear while the device is
being activated if:
R COMAND does not support the device
connected (No Device Connected).
R two devices are connected simultaneously
(Please make sure that only one
device is connected).
R the connected device consumes too much
power.
R the Media Interface connection is faulty.
i Where necessary, consult an authorized
Mercedes-Benz Center.
Switching to Media Interface mode
General notes
In extreme cases, starting up individual
functions can take up to several minutes –
this depends on the external device and its
content (e.g. video podcasts).
Only use the original software to save files on
iPods or MP3 players. Some or all functions
may not be available otherwise.
Option 1
X
Connect an external device (
Y
page 143).
COMAND activates the device. The basic
display then appears.
or
X Select Audio in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
If you had previously selected Media
Interface mode, this will now be activated.
If another audio source is switched on, you
can now switch to Media Interface mode in
the audio menu.
Media Interface mode
143
Audio
ZA COMAND NTG4.0 BR204 USA Edition A 2011; 1; 3, en-US
d2irenkl Version: 3.0.3.6
2010-05-31T09:21:57+02:00 - Seite 143
Z