Losi LOSB9595 User Manual
Page 6
Instructions for Losi Xcelorin 36
th
Electronic Speed Control / Motor
Page 6 of 8
Operating the Quick Programming Card (QPC)
To program or reprogram the electronic speed control follow these steps:
1. Change the small jumpers on the QPC to the desired settings.
2. Connect the battery so that the ESC has power; leave the switch in the OFF
position.
3. Disconnect the ESC radio lead from the receiver.
4. Connect the radio lead to the QPC top just left of center when looking at card
from the backside.
Note: On this connection, it is important to verify you plug it in correctly.
See photo below and notice that the Negative (-) is on the left, in the center
is Positive (+) and the pulse (or signal) is on the far right (P).
Note: On the ESC connector Brown is (-) and Red (+) and Orange (P)
5. Turn the power switch to ON. Notice the Red LED will flash and then become
solid Red. Programming is complete.
6. If you wish to make another change at this time, turn off the power and make
changes to jumpers, otherwise turn off the power switch before proceeding.
7. Disconnect the radio lead from the QPC and reconnect to the receiver.
8. You are now finished programming the ESC.