Losi LOSB9595 User Manual
Page 4
Instructions for Losi Xcelorin 36
th
Electronic Speed Control / Motor
Page 4 of 8
Warnings:
Continued
o
Rubber tires can cause severe injury if there is a failure while running
the vehicle while on a stand or when being held. Ensure Rubber tires
are securely mounted and if not re-glue them and check them often
for potential failure.
• Disconnect the battery from the ESC after use.
• Electronic Speed Control (ESC) is not waterproof and should not be exposed
to moisture.
• Do not attempt to use with more than 2-cell LiPo, or six cells NiMH; doing so
will damage the ESC and could result in a fire.
• Mount ESC securely for use.
• Avoid over-tightening of the motor screws. Damaged threads are not covered
under warranty.
Electronic Speed Control Setup:
1. Please read all safety precautions prior to use.
2. Ensure installation is complete and all connectors checked for polarity, ready
for use.
3. Battery is charged and operational.
4. Set the Throttle and Brake throw on your transmitter to 100% (if they are
adjustable).
5. Set the Trim to the centered position.
6. Ensure that the Throttle channel is in the “normal” position and not “reverse”.
If in reverse when you perform step 8, the LED will stay Green until you set
to “normal”.
7. Turn the ESC power switch OFF
。
8. Locate the SETUP button on the ESC, press SETUP button, turn the ESC
power switch to ON and hold SETUP button until the Green LED is ON solid.
9. Pull throttle trigger to the full throttle position, the Green LED will be flashing
and then Blue LED turns ON solid.
10. Now push the throttle trigger to full brake, the blue LED is flashing, and then
Green and Blue LEDs both turn on solid.
11. Release throttle to neutral position. The Green and Blue LEDs are flashing,
and then will both be ON solid.
12. Turn off the ESC power switch; this saves the calibration to the ESC. You
have calibrated the ESC for your transmitter.
Note: Should you change transmitters or receivers you must
repeat the above steps to re-calibrate the ESC.