Command syntax netbootloader, Run (asmp) – Kontron NetBootLoader User Manual
Page 75

ID 1022-8317, Rev. 2.0
Command Syntax
NetBootLoader
Page 67
RUN
(ASMP)
FUNCTION:
(Loads and) starts (a) bootable image(s)
SYNTAX:
run [-c] [
where:
run
command
-c
option: check
do not start the image(s) if the “md5” check failed
parameter: string
0, 1, 2, 3
load and start image with the number
from NBL Flash on core 0
4
start image in the data buffer on core 0
- 1
do not start image on core 0
parameter: string
0, 1, 2, 3
load and start image with the number
from NBL Flash on core 1
4
start image in the data buffer on core 1
- 1
do not start image on core 1
DESCRIPTION:
This command is used to (load and) start (a) boot images for both
cores.
If the image to be started is located in the NBL Flash, it is loaded to
the data buffer and then started.
If the image to be started is already located in the data buffer it is
started.
When used with the “-c” option, only a valid image is started. If both
cores are to be used, then both images must be in order or neither
image will be started. Refer to the LOAD command for further
information.
Invoking RUN without options starts images in the data buffer.