Kontron NetBootLoader - Manual (Page 74)

ID 1022-8317, Rev. 2.0
Command Syntax NetBootLoader
Page 66
RS
FUNCTION: Reset the system
SYNTAX:
rs
DESCRIPTION: To permit the operator to force a restart of the system, the command
RS is used.
This command terminates the NetBootLoader command interpreter
and resets the entire system.
If this command is issued over a remote telnet connection, the telnet
session is terminated prior to the generation of the reset.
RUN (SMP)
FUNCTION: (Loads and) starts a bootable image
SYNTAX:
run [-c|]
where:
run command
-c option: check
do not start the image if the “md5” check failed
parameter: string
0, 1, 2, 3
ID number of the image to be booted
no other values than those above are supported
if no image is specified, the image in the data buffer
is booted
DESCRIPTION: This command is used to (load and) start a boot image.
If the image to be started is located in the NBL Flash, it is loaded to
the data buffer and then started.
If the image to be started is already located in the data buffer it is
started.
When used with the “-c” option, only a valid image is started. Refer to
the LOAD command for further information.