Kontron NetBootLoader - Manual (Page 67)

ID 1022-8317, Rev. 2.0
Command Syntax NetBootLoader
Page 59
DESCRIPTION: To set or display the parameters of an Ethernet port the command
NET is used.
Initially the CPU board does not have any valid Ethernet port
configurations, therefore, these interfaces are inoperable. The initial
configuration of the Ethernet ports must be done from the primary
serial interface using the command “net ... -f”.
Using the “-f” option forces a CRC to be performed and stored along
with the other configuration parameters in the serial EEPROM.
Once the configuration of an Ethernet port is done, it is available for
operation. Later changes to the parameters do not require the use of
the “-f” option to force a CRC. This is done automatically.
If the NET command is issued without any parameters, the current
parameter settings of all the Ethernet ports is displayed.
NET (AMC)