beautypg.com

Command syntax netbootloader, Dhcp – Kontron NetBootLoader User Manual

Page 43

background image

ID 1022-8317, Rev. 2.0

Command Syntax

NetBootLoader

Page 35

DHCP

FUNCTION:

Interface to a DHCP or BOOTP server; exchange network
configuration parameters

SYNTAX:

dhcp [-e|]

where:

dhcp

command

-e

option:
continue sending requests until answer is received

parameter: value: numeric string
<[n … ]n>

time, in seconds; must be

5 seconds

DESCRIPTION:

This command is used to set the network parameters for operation of

an Ethernet port via either a DHCP or BOOTP server.
Initially the board does not have a valid Ethernet interface
configuration, and, therefore, this interface is inoperable. The initial
configuration must be done either manually from a serial interface
using the command NET, or, if a DHCP or BOOTP server is available,
it can be done automatically by the DHCP command.
Manually configured parameters are permanently stored. Parameters
configured using the DHCP command are temporary and will be lost if
the system is reset or cold started.
Some products require that the IP address be set to 255.255.255.255
with the NET command prior to using the DHCP command.

USAGE:

Program NetBootLoader (normal operation)

COMMAND / RESPONSE:

NetBtLd> dhcp

Sending request... reply from BOOTP/DHCP

server.

Network initializated ok.

Server address is 192.168.112.2, our IP

... address is 192.168.112.14.

Filename :

NetBtLd>