Elecraft KAT100 - Manual (Page 4)

4
Parts Inventory
You should do a complete inventory, and if you find anything missing, contact Elecraft.
i
Leave painted panels wrapped until they are needed during assembly. This will protect the finish.
Items supplied only with the KAT100-1 (with low-profile enclosure).
Picture Ref. Designator(s) QTY Description Part #
MISC 1 KAT100-1 Front Panel E100138
MISC 1 KAT100-1 Rear Panel E100139
MISC 2 KAT100-1 Side Panel E100140
MISC 1 KAT100-1 Top Cover E100146
MISC 1 KAT100-1 Bottom Cover (note: includes holes for optional feet/tilt-stand) E100147
The items below are in a small bag labeled "Misc., KAT100-1" (p/n E850132)
HDWR 28 Screw, 4-40 x 3/16" Panhead Phillips, black (includes several spares) E700015
HDWR 8 2-D Fastener E100078
MISC 4 Rubber foot, self-adhesive E700024
MISC 2 Anti-slide bracket E100150
Items supplied only with the KAT100-2 (for use with an EC2 enclosure).
Picture Ref. Designator(s) QTY Description Part #
MISC 1 KAT100-2 Front Panel, EC2-compatible E100142
MISC 1 KAT100-2 Rear Panel, EC2-compatible E100143
The items below are in a small bag labeled "Misc., KAT100-2" (p/n E850136)
P3, P6 2 Connector, 2 pin male, 0.156"spacing (Aux 12V In and Aux RF Out) E620012
P 4 1 Connector, 10 pin (5x2) male, 0.1" spacing (Aux Control) E620040