EFCO Special Purpose Windows Installation - Manual (Page 28)

EFCO CORPORATION 3/5/2014 PART NO. YW40 Page 1 of 2
Window Installation Instructions - Sliding Window Installation Section -
Horizontal Sliding Window Sash Removal
1.
Remove sash stop (HB53) by removing screw (STK0). The sash stop is located in the head track
opposite the sash.
2.
Remove anti-rack / anti-takeout filler (LB24) by pulling down on the side nearest the jamb. This
end is next to sash stop you just removed.
Completely read the General Installation Instructions and all other sections which pertain
to your project before starting work. These recommendations are for general erection
procedures only. For actual job conditions, see the details on the shop drawings. For
perimeter anchor types and spacing, refer to the approved shop drawings or consult the
project design professional.
LB24
Interior View
Interior View