Dynojet 224x: Installation Guide - Manual (Page 41)

I N S T A L L A T I O N
Logo Panel Installation
Version 4 Above Ground Model 224 Automotive Dynamometer Installation Guide
2-21
2 Secure each mounting bracket to the dyno using two 3/8-16 x 3/4-inch hex bolts
and two 3/8-inch flat washers.
There are two mounting brackets per logo panel.
Figure 2-17: Install the Mounting Brackets
3 Secure the logo panel to the mounting brackets using five 1/4-20 x 5/8-inch pan-
head torx screws.
Figure 2-18: Install the Logo Panel
mounting bracket
logo panel