Dynojet 224x: Installation Guide - Manual (Page 28)

Above Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 2
Dyno Installation
2-8
3 Align the interface guide pin on the lift cross member with the interface bracket
on the dyno. The interface bracket is already installed on the dyno.
Note: The distance between the dyno and the lift may need to be adjusted.
4 Lower the lift until the interface guide pin just starts to enter the interface bracket
on the dyno.
Figure 2-5: Align the Interface Bracket and the Interface Guide
AD209
interface bracket
on dyno
(dyno not shown
for clarity)
pin
mounting bolt
lift cross
member