Dynojet 224x: Installation Guide - Manual (Page 22)

Above Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 2
Unpacking and Inspecting the Dyno
2-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
UNPACKING AND INSPECTING THE DYNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipper or Dynojet
before proceeding with unpacking.
Use the following steps to unload your dyno. You will need to provide equipment
capable of lifting a minimum of 2,722 kg. (6,000 lb.) to move the crated dyno into
position in your dyno room. Refer to “Forklift Requirements” on page 1-7 for more
information.
1
Move the crated dyno to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, remove the top and
sides of the crate.
3 Inspect the exterior of the dyno for any indications of damage. Report any
damage immediately.
4 Remove the boxes and loose parts from the crate, verify their condition and
contents and set them aside.
part description part description
The following parts are included in the Above Ground Kit P/N 78112001:
ground hook/D-ring (6)
P/N 10111
support angel, rear deck (2)
P/N 21610807
D-ring bracket, surface
mount (6)
P/N 10112
brace mount, rear deck (2)
P/N 21614102
mounting bracket, logo
panel (4)
P/N 21200004
rear deck tube
P/N 21619103
lower mounting bracket
logo end panel (2)
P/N 21200009
brace, rear deck (4)
P/N 21714200
center panel, rear deck
P/N 21214300
cap plug, 1.75" x 1/2",
black (2)
P/N 35521420