Dynojet 224x: Installation Guide - Manual (Page 31)

I N S T A L L A T I O N
Cable Routing
Version 4 Above Ground Model 224 Automotive Dynamometer Installation Guide
2-11
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CABLE ROUTING
Use the following instructions to route the cables. You will need to route the cables
before installing the deck.
C ONNECTING THE D YNO E LECTRONICS AND S HOP A IR
You will need the following parts:
• 318110301 Power Cord
• 42924250
25-pin Cable
• 53415040 Power Supply
• 76199003N Dyno Electronics
1 Route the 25-pin cable from the dyno electronics to the Breakout board. Connect
the 25-pin cable to the Breakout board.
Refer to page 1-9 for more information on connecting to the dyno electronics.
Refer to page 2-13 for more information on wiring the Breakout board.
2 Connect the air hose to the T fitting on the dyno brake solenoid.
Note: The air brake comes installed with a hose barb for a 3/8-inch inside
diameter air hose. If your hose does not have an inside diameter of 3/8-inch then
you will need an air hose nipple (1/4-inch NPT) to connect your clean, dry shop
air supply to the dyno. Once the pressure is connected, the air brake is ready to
use.
3 Connect the power supply to the dyno electronics. Plug the power supply into
your power source.
Figure 2-8: Routing the Cables
AD217
power supply for
dyno electronics
breakout board
dyno electronics dyno electronics
cable
shop air