Dynojet 224x: Installation Guide - Manual (Page 38)

Above Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 2
Deck Installation
2-18
7 Remove the center bolt from the drum guard and set aside.
8 Secure the supports to the outer panels using three 1/4-20 x 5/8-inch screws and
crush nuts each.
9 Secure the center panel to each support using three 1/4-20 x 5/8-inch screws and
crush nuts each.
10 Secure the center panel to the dyno with the center bolt removed earlier.
Figure 2-14: Install the Center Panel
AD221
center panel
outer panel
support angle
center bolt