Dynojet 224x: Installation Guide - Manual (Page 37)

I N S T A L L A T I O N
Deck Installation
Version 4 Above Ground Model 224 Automotive Dynamometer Installation Guide
2-17
6 Install the outside panels.
6a
Secure the panel to the dyno frame using three 3/8-16 x 1.5-inch flange-hex
bolts.
6b Secure the three tie-downs to the panel and to the deck braces using two
3/8-16 x 1.5-inch flange-hex bolts, two 3/8-inch washers, and two 3/8-inch
nylock nuts each.
Verify the panel is sandwiched between the tie-downs and the brace.
6c Secure the inside of the panel to the inner brace using one 3/8-16 x 1.5-inch
flange-hex bolt, one 3/8-inch washer, and one 3/8-inch nylock nut.
Figure 2-13: Install the Outside Panels
AD220
step 6c
secure the panel
to the inner brace
tie-down
outside panel
outer brace
inner brace
step 6a
secure the panel
to the dyno frame
step 6a
secure the panel
to the dyno frame