Dynojet 224x: Installation Guide - Manual (Page 36)

Above Ground Model 224 Automotive Dynamometer Installation Guide
C H A P T E R 2
Deck Installation
2-16
3 Loosely install the inner rear deck braces to the dyno using two 3/8-16 x 1.5-inch
flange-hex bolts each.
4 Loosely install the outer rear deck braces to the mounting brackets using two
3/8-16 x 1.5-inch flange-hex bolts, washers, and nylock nuts each.
Note: If you have and eddy current brake, the outer rear deck brace will secure
directly to the brake with no mounting bracket.
5 Verify there are no bolts securing the left and right drum guards in the locations
shown in Figure 2-12.
Figure 2-12: Install the Rear Deck Braces
AD261
mounting bracket
outer brace
inner brace
outer brace
mounting bracket
left drum guard
right drum
guard
verify there is no
bolt in this hole
verify there is no
bolt in this hole