BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 4)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 4
Step 2: Mounting The Airbox and ECU
Parts Needed: Tools Needed:
2- Machined rings/o-rings installed Drill with 5/16 drill bit
Air temp sensor (removed from stock airbox) Basic tool set
Boondocker airbox Assembly lube
2- self tapping sheet metal screws Silicone
5/16 x ¾” bolt with lock washer
2- Rubber ECU mounts
A. Lubricate the o-rings on the machined rings, this
will help ensure a good o-ring seat. Install the
rings to the throttle bodies as shown.
B. Insert the airbox over the machined rings. Mark
and drill a 5/16” hole in the throttle body
support for the airbox mount.
C. Use silicone around the factory temp sensor to
help seal this connection. Be sure not to get any
silicone on the sensor itself. Install the sensor in
the predrilled hole in Boondocker airbox using
the provided self tapping screws.
Drill here