BoonDocker ARCTIC CAT: 800/1000 Turbo - Manual

BoonDocker – 2379 Heyrend Way Idaho Falls, Idaho 83402 – (208) 542-4411
website: www.boondockers.com - email: [email protected]
Revised 03-14-07 Page 1 of 18
M8 / M1000 Arctic Cat Turbo (Auxiliary Injector)
EFI Control Box Instructions
Before you begin, please read all the instructions below and check kit contents.
Kit Contents:
Quality check by:
___1 Control Box
___1 EFI harness
___2 black connectors
___1 battery/jumper connector
___1 Reusable Zip Tie
Arctic Cat Wiring Harness Connector Assembly Instructions
The two black connectors must be installed on the Control Box EFI harness as shown below before continuing with the
installation.
All Models: Connect a test light to the chassis ground. Unplug a stock injector. Connect the other connector of the
test light to one of the contacts on the stock injector connector. Pull the starter rope and watch for the test light to
come on. If there is no light, try the other contact terminal. The terminal that produces light is positive.
After you have determined which of the terminals is positive, insert the red wire of the BoonDocker harness into the
black connector to correspond with the positive wire on the factory connector.
Insert the terminals into the connectors by following the steps below:
1. Non-1000 connector: Hold the black connector
with its locking tab up. Insert the terminal with its
alignment tabs up (see picture).
1000 connector: Orient the black connector and pin
terminal as shown in picture.
Note: Look inside black connector to verify that the
lock tab inside will mate with the slot in the terminal
(below guide tabs).
2. Push the terminal into the black connector. The
terminal will go part way into the connector and stop.