BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 15)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 15
E. Reinstall the bottom heat shield on the pipe and
install the exhaust pipe as shown in picture Be
sure to spring the pipe in place to ensure proper
placement (use factory springs).
F. We are now ready to weld the inlet to the exhaust
pipe. Either mark the inlet and pipe with a
permanent marker and remove pipe to tack and
weld, or If you plan on tacking the inlet to the pipe
on the sled, be sure to disconnect the ECU failure
to follow this step will result in damage to your
ECU. Remove pipe and finish the weld.
NOTE: Do not reinstall the exhaust pipe until you
complete step 9.