BoonDocker POLARIS: 2007-10 Dragon Pump Gas - Manual

BoonDocker Performance 1585 Hollipark Dr. Idaho Falls, ID 83401
Toll Free (US) 877-552-6127 or 208-542-4411 www.boondockers.com
Revised 10/01/2010 Page 1
Pump Gas Instructions for Polaris 600 700 And 800 Models
Important Information before Installing This System:
Before you begin your turbo install, read through these instructions to determine if you are
comfortable installing this system. If not please take it to an experienced mechanic for your install.
It is also a good idea to check the kit contents to verify all parts were provided in the kit before
getting started. This install requires time and patience. Do not rush the installation, if you have any
questions on your installation please contact Boondocker tech support at 1-877-522-7805.
 Improper installation could result in engine damage or personal injury.
 For the 2007 Dragon 700 we strongly suggest upgrading from the stock pistons
please call for details.
 It is highly recommended to run the factory reeds or the reeds recommended by
Boondocker. Some aftermarket reeds can break and cause engine damage.
Step 1- Disassembling your sled:
Tools Needed:
Basic Tool Set
A. Remove side panels
B. Remove the electrical cover (plastic) from the clutch cover.
C. Remove the sensor from the exhaust pipe, then remove the pipe and exhaust muffler. Be sure to
keep all of the exhaust springs, you will need these later in the install.