BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 16)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 16
Step 10: Exhaust Pipe Final Install
Parts Needed: Tools Needed:
Air saw or band saw
4- High tension exhaust spring Basic tool kit
4- 8mm x 25mm bolts Spring tool
4- 8mm top lock nuts Black high temp spray paint
4 Hole exhaust gasket (packaged in turbo box)
Exhaust Pipe with heat shield
Factory heat shield
A. For a cleaner look, paint the welded inlet on the
exhaust pipe with a black high temp spray paint.
B. Reinstall the factory heat shield on exhaust pipe.
C. Using an air saw or band saw trim the exhaust heat
shield as shown in picture
D. Reinstall the heat shield to the sled
E. To save you a headache install the 2 high tension
exhaust springs on the right side of the pipe first,
this allows you to use the exhaust pipe to torque the
springs instead of a spring puller. Be sure to install
the short hook onto the pipe side and the long side
of the spring to the Y pipe.
F. Be sure to add the 4-hole gasket on the turbo side
of the pipe. Fasten this connection using the
provided 8mm bolts with lock nuts.
G. Install the remaining high tension exhaust springs