BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 12)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 12
Step:8 Fuel System
Parts Needed: Tools Needed:
Fuel regulator fitting Basic tool set
2- 1/8” NPT x 1/8” PTC 90 Vise
41” of 1/8” poly line Drill w/ 5/16” drill bit
Bulkhead fitting with 1/8” push to connect Nut driver
5/16 nylon lock nut
1/4 “ flat washer
4- 8” cable zip ties
7” of clear 3/16” tubing
Boondocker airbox
A. Disconnect and remove the electrical connector, fuel
line, brass fitting and the nut shown in picture, then
remove the factory fuel pump from the gas tank.
B. Locate the brass fuel regulator fitting and using a
9/16” socket press the fitting on the stock fuel
regulator using a vise as shown in picture.
C. Thread the 1/8 push to connect 90 into the copper
cap as shown in picture
D. Reinstall the fuel pump in gas tank.
E. Find a flat surface on the fuel tank to mount the
bulkhead fitting. Drill a 5/16” hole and install the
bulkhead union in gas tank. Fasten the bulkhead
fitting using the provided 5/16 lock nut and ¼” tighten using a nut driver. IMPORTANT:
Do not over tighten this fitting it will break.