BoonDocker EBC - Manual

BoonDocker Performance 2379 W. Heyrend Way Idaho Falls, ID 83402
Toll Free (US) 877-552-6127 or 208-542-4411 www.boondockers.com
Revised 10-28-11 Electronic Boost Controller install/operation instructions Page 1
Installation and Operation Instructions
Electronic Boost Controller (Rev. F1)
Contents list:
Before installation of your Boondocker Electronic Boost Controller (EBC), check the contents of your kit.
Find the appropriate list for your application in the Appendix.
Installation
After installation, calibration is required! (See page 2.)
Install the boost solenoid in a pressure line between the air box (or charge tube) and wastegate actuator.
Attach the metal port of the solenoid with a 3/16” hose to the air box (or charge tube) fitting (see the
figure below). Connect the right-angle port of the solenoid with a 3/16” hose to the wastegate actuator.
Attach a short length of hose to the third port and point it downward so that it won’t get water in it. This
is the actuator vent hose. Attach the solenoid so that it is supported. Use small zip ties to secure the
hoses to the ports.