BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 10)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 10
B. Wiring your oil pump. Use the Voltage Regulator Power Adapter (supplied in the kit,
see picture), plug in between the chassis harness and voltage regulator (see picture). If
you have an Intercooler with fan you will connect here also.
Step 7: Installing Water Lines
Parts Needed: Tools Needed:
2-Banjo style water fittings 1 @ 17” 1 @ 19’’ Basic tool set
2- Bolts for Banjo fittings 4- Copper washers
1-¼” x ¼” barbed fitting
T20 torx head bit.
A. To route the water lines tilt the sled on its side
and remove the belly plate using a T20 torx head
bit.
B. Locate the factory water line that runs from the
throttle bodies to the back of the motor. Pinch the
factory water line with a pair of vise grips or
other clamping pliers and remove the factory
clamp Note: you may have to rotate the clamp to
gain access to
The worm drive fastener on the hose clamp.