BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 3)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 3
C. Remove Y pipe and heat shield. Note: If
you are installing EGT’s now would be the
time to weld on the EGT bungs. Be sure to
mount them 2 ½” from the flange.
D. Remove airbox from nose cone and
remove the plastic boot that connects to
the throttle bodies.
E. Remove the temp sensor from the airbox
and set it aside, you will need this later in
the install.
F. Remove right hand step panel and reverse
beeper.
G. Cut and remove this portion of bulk head
using an air saw, if you do not have an
airsaw you can work this piece loose with
a pair of pliers.