BoonDocker ARCTIC CAT: 2010-11 M8 Pump Gas - Manual (Page 14)

BoonDocker Performance www.boondockers.com 208-542-4411 2010 M8 Turbo Kit Instructions 14
Step 9:Exhaust Pipe
Parts Needed: Tools Needed:
Air saw or band saw
4- 8mm non Nylon lock nuts Welder
Stock pipe Basic tool kit
Boondocker turbo inlet Grinder or sand paper
4- 8mm x 25mm bolts
A. Remove stock heat shield from pipe.
B. Cut the exhaust pipe right before the weld as
shown in picture. You will also need to grind
about 1.5” inches off the factory weld of the
pipe as shown in picture.
C. Sand the end of the pipe and the inlet for a
clean weld on the pipe
D. Bolt the turbo inlet to the exhaust housing on
the turbo as shown using the provided 8mm
bolts and nuts Note: the exhaust housing side of
the turbo should still be loose, this will allow
you to rotate the housing as needed to fit the
exhaust pipe.