Salter Brecknell SBI140 - Manual (Page 9)

4
(2)
Choose weighing units among kg-lb-lb: oz
Note: The weighing units that can be used are restricted by display
division, and calibration weight unit (restricted by P8, P9, and P10):
For example, if the calibration unit is “kg”; calibration display resolution
is 50kg (that means: P8=5, P9=0, P10=0), and users press UNIT key to
choose weighing units. Lb or lb:oz are not allowed to choose, since the
display resolution of 100lb or 2000oz is not available to this indicator.
(3)
Tare the weight. This function can be activated only when the scale is in
stable mode and the gross weight is not negative value.
(4)
Zero function. When the weight is within zero range, it will active as
ZERO function and clear the tare weight. When the weight is not within
zero setting range (P13 set), the scale will show 0
ˉ ˉ ˉ ˉ
(zero point is over
the setting range), or 0
_ _ _ _
( zero is below the setting range).
3.2. In normal weighing mode and hold down time longer than 3s:
(1) Same meaning with that in 3.1
(2) Same meaning with that in 3.1
(3) Same meaning with that in 3.1
(4) Power off the scale.
UNIT
TARE
ZERO
HOLD
PRINT
UNIT TARE OFF
HOLD
PRINT
UNIT
TARE
OFF